Author: Fors, T.
Paper Title Page
TUZGBD3 Beam Diagnostics for the APS MBA Upgrade 1204
 
  • N. Sereno, N.D. Arnold, R.W. Blake, A.R. Brill, H. Bui, J. Carwardine, G. Decker, L. Emery, T. Fors, P.S. Kallakuri, R.T. Keane, R.M. Lill, D.R. Paskvan, A.F. Pietryla, H. Shang, X. Sun, S. Veseli, J. Wang, S. Xu, B.X. Yang
    ANL, Argonne, Illinois, USA
 
  The Advanced Photon Source (APS) is currently in the preliminary design phase for a multi-bend acromat (MBA) lattice upgrade. Beam stability is critical where the requirements are driven from the beam size which is expected to approach 4 microns vertically at the insertion device (ID) source points. AC rms beam stability requirements are defined as 10 % the minimum source size at the ID in the band 0.01-1000 Hz. The vertical plane stability goal is the most ambitious requiring a stability of 400 nm at the ID source point. In addition, long term drift defined as motion over a seven day timescale can be no more than 1 micron. In order to achieve these demanding beam stability requirements, a suite of beam diagnostics will be required including rf BPMs, X-ray BPMs, a mechanical motion measurement system, beam size monitors and a real time orbit feedback system. In addition, a tune measurement system, transverse multi-bunch feedback system and current monitors are planned for the upgrade. We report on the beam diagnostics design and APS storage ring R&D results used to inform the design.  
slides icon Slides TUZGBD3 [16.753 MB]  
DOI • reference for this paper ※ https://doi.org/10.18429/JACoW-IPAC2018-TUZGBD3  
Export • reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)  
 
WEPAF007 A Scheme for Asynchronous Operation of the APS-U Booster Synchrotron 1823
 
  • U. Wienands, T.G. Berenc, T. Fors, F. Lenkszus, N. Sereno, G.J. Waldschmidt
    ANL, Argonne, Illinois, USA
 
  Funding: Work supported by US DOE
The APS-U 6-GeV MBA storage ring will have 42 pm beam emittance and relatively tight acceptance. This requires limiting the beam emittance out of the Booster synchrotron which is achieved by operating the Booster off-momentum, thus manipulating the damping partitions. However, the much higher charge for the APS-U strongly favors injecting on momentum into the Booster for maximum acceptance. An rf-frequency ramping scheme is proposed to allow injecting on momentum and then moving the beam off momentum. The ramp is adjusted from cycle to cycle to vary the total time taken by the beam from injection to extraction, thus aligning the Booster bunch with any chosen MBA storage ring bucket. The two rf systems will not be locked at any time of the cycle. The proposed scheme is compatible with the existing synchronization of the APS injector cycle to the 60-Hz line voltage which induces a variation in the start time of the acceleration cycle. The scheme removes the need to realign the Booster ring for total path length while optimizing its operation for high charge acceleration. A ferrite tuner is being considered for dynamic tuning of the rf cavities.
 
DOI • reference for this paper ※ https://doi.org/10.18429/JACoW-IPAC2018-WEPAF007  
Export • reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)